INPUT

1. Input Voltage

   If Auto Select :  Range :  Vac to Vac.

   If Universal or Full Range : Range :   Vac to Vac

    

2. Input Frequency

   From Hz to Hz  (normally 47 ~ 63 Hz.)

    

3. Input Current :  Amp.

    

4. Inrush Current:

    A ( max.) at 115Vac and A (max.) at 230Vac.

   ( Inrush current measurement done during cold start at 25 deg. C ).

    

5. Power Efficiency :

   % min. at full load, Vac, 60Hz or 50Hz.

    

6. With direct-wired AC cord or with IEC Inlet.

   Please specify:  AC cordIEC Inlet

    

7. AC Plug required ( if any ) :

   US    UK    Europe    Australia

   Other, please specify

    

8. AC wire length:  metres.

OUTPUT

1. Output Voltage and Current

   Output voltage : V +/- %

   Output current : A +/- %

    

2. Total maximum output power :   Watts.

    

3. Ripple and Noise mV at volts. and amperes.

   ( mV peak to peak )

    

4. No. of charging stages required. Please specify:

   2 stages

   3 stages

   4 stages 

    

5. Constant voltage:  V ( +/- % )

   Float voltage:  V ( +/- % )

   Constant current :  A ( +/- % )

   Switching current ( during start of float voltage ) :  A

    

6. Length of DC wires :  metres.

    

7. Type of DC connector required : 

PROTECTION FEATURES

1. If battery charger latches into a shutdown mode ( when OCP, OVP or short-circuit protection is working ), battery shall recover to normal operation by:

   Auto –  recovery when the fault has been removed OR

   Manual – recovery ( fault removed and off / on switch )

    

2. Short circuit protection.

   All outputs ( except inhibit or interlock ) is short circuit protected to ground.

   Yes    No

    

3. Over voltage protection:

   V to V  ( for OVP sense level ).

    

4. Reverse  polarity protection :

   All DC volt. outputs are reverse – polarity protected.

   Yes    No

    

5. Over current protection:

   Normal short circuit protection is acceptable without OCP in most

   Applications.:

   Yes, please specify  V     Amp. max.

   No

    

6. Over temperature protection . ( state if required ).

   Yes, please specify cut-off temperature:  º C.

   No

    

ENVIRONMENTAL REQUIREMENTS

1. Ambient Operation Temperature            to º C.

    

2. Ambient Operation Relative Humidity   to %.

    

3. Ambient Storage Temperature                to º C.

    

4. Ambient Storage Relative Humidity       to %.

EMI REQUIREMENTS

State the requirements below :

Fan required, with airflow of CFM

Fan not required

Length ( L ) : mm    Width ( W ) : mm    Height ( H ) : mm

Metal    Plastic    Other, please specify: 

1. On-board charger  OR Off-board charger

    

2. Special packing requirements:

    

3. Inhibit or Interlock signals required?

   Inhibit    Interlock    not required

    

4. Need with remote LEDs:

   Yes    No

    

5. Additional requirements: